Burst Strength Attachment (ASTM D). Brochure Share. Request Info . Product Details Standards Get a Quote. Product Details. Burst Strength. ASTM D determines the measurement for bursting strength with a ball burst strength tester of textiles or garments that exhibit a high degree of ultimate. Page 1. — — 27 —>. Ø K-. k— ASTM D Fixture.
|Published (Last):||28 January 2015|
|PDF File Size:||7.75 Mb|
|ePub File Size:||4.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
For the measurement of bursting strength with a hydraulic testing machine, refer to Test Method D Historical Version s – view astm d3787 versions of standard. Combining values from the two systems may result in nonconformance within the specification.
The test samples used should be as homogeneous as possible, drawn astm d3787 the material from which the disparate test results were obtained, and randomly assigned in astm d3787 numbers to the laboratories for testing. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Test Method D is considered satisfactory for acceptance testing of commercial shipments of textiles fabrics astm d3787 bursting strength since the method has been used extensively in the trade for acceptance testing.
The kind astm d3787 force transfer and strength that occur when knitted goods are worn is prevented by clamping them as directed in astm d3787 test method. Asgm materials with established test values may be used for this purpose.
ASTM D Ball Burst Textiles Constant Rate Traverse CRT Test Equipment
The values stated in each system are not exact equivalents; therefore, each system may be used independently astm d3787 the other. Referenced Documents astm d3787 separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
This standard does not purport to address all of the safety concerns, d37877 any, astm d3787 with its use. In cases of disagreement arising from differences in astm d3787 reported by the c3787 and the seller when using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined with comparison based on testing specimens randomly drawn from one sample of material astm d3787 the type being evaluated.
ASTM D – Ball Burst Puncture Fixture
Within the test, the astm d3787 units are shown in parentheses. If a bias is found, either the cause must be determined and corrected or future test results must be adjusted in consideration of known bias.
Link to Active This link will always route to the current Active version of the standard. The test results from the two laboratories should be compared using a statistical test for unpaired data at a probability astm d3787 chosen prior to the testing series.